To add your custom installation path you can refer to this HowTo 64 bits: %ProgramW6432%\STMicroelectronics\STM32Cube\STM32CubeProgrammer\bin.32 bits: %ProgramFiles(X86)%\STMicroelectronics\STM32Cube\STM32CubeProgrammer\bin.Linux: $HOME/STMicroelectronics/STM32Cube/STM32CubeProgrammer/bin.

User can change the default install path but in this case, the new path have to be added in the PATH environment variable.ĭefault path of STM32CubeProgrammer binary: To use those upload methods, STM32CubeProgrammer have to be installed manually as it is not provided through the tools packages. Three upload methods are based on the STM32CubeProgrammer CLI (command-line interface): STM32CubeProgrammer allows to write and verify device memory through both the debug interface (JTAG and SWD) and the bootloader interface (UART, USB DFU, I2C, SPI, and CAN). Once programmed into the MCU the copied binary disappears from the virtual disk. The mass storage device of the ST-Link is a virtual disk, copy on this disk a binary will program it. This enables drag-and-drop flash programming, so there is no need for a separate debug probe. This upload method is mainly dedicated to boards manufactured by ST which integrate a ST-Link: Nucleo, Discovery, Eval.